Epson-sx130-reset Adjustment Program

To use the Epson SX130 reset adjustment program, follow these steps:

There are two primary ways users typically handle this reset: WIC (Waste Ink Counter) Reset Utility

Open the bottom/rear casing of the printer, carefully remove the saturated foam pads, wash them thoroughly in warm water, dry them completely, and reinstall them. epson-sx130-reset adjustment program

Zeroes out the Main and Platen pad counters.

Once the counter hits 100%, the printer locks itself to prevent ink from overflowing and damaging your desk or internal circuitry. To use the Epson SX130 reset adjustment program,

If you reset the counter multiple times without addressing the physical ink buildup, the pads will eventually oversaturate, leading to permanent internal damage or ink leaking out of the bottom of the printer.

Inside the printer, porous foam pads collect excess ink during initial setup, print head cleaning cycles, and borderless printing. If you reset the counter multiple times without

: Turn off the printer when prompted, then click Finish .