Hanmatek Dos1102 Manual _verified_ -

Moves the entire waveform up or down on the screen. 3. Horizontal System (Time Base Controls) This zone controls the horizontal axis (Time).

Yes, but check Hanmatek’s website first. The manual explains the update process via USB drive. Incorrect firmware can brick the scope.

Take your standard passive probe and flip its attenuation switch to . Connect the probe to the CH1 BNC input.

To help tailor any further assistance, could you let me know if you are troubleshooting a , trying to connect to a particular operating system , or looking for instructions on a specific measurement type ? Share public link hanmatek dos1102 manual

Choose your cursor type: (horizontal lines) or Time (vertical lines).

This comprehensive guide serves as an expanded manual to help you set up, calibrate, and master your Hanmatek DOS1102. Technical Specifications Overview

Can limit the scope to 20MHz to filter out high-frequency background noise. Invert: Flips the waveform 180 degrees vertically. Trigger Menu Moves the entire waveform up or down on the screen

Look at the square wave on the screen. If the corners are rounded (under-compensated) or have spikes/overshoot (over-compensated), use the small plastic screwdriver included with your probes to adjust the adjustment slot inside the BNC end of the probe. Rotate it until the tops and bottoms of the square wave are perfectly flat. 4. Navigating the Menu System and Features

Sets the voltage point that the signal must cross to trigger the display sweep.

For most standard electronics work, set this switch to . This increases the input impedance and prevents the oscilloscope from loading down (interfering with) your circuit. Yes, but check Hanmatek’s website first

The probe is over-compensated.

: Minimum 10K sampling points per acquired waveform.

Adjusts the timebase scale (zoom in or out horizontally to change the time value per grid square). The Trigger Control Zone