Mobotix M10 Open Menu

: The factory default IP address for most MOBOTIX cameras is 10.0.0.19 . If you have changed it, use a network scanner or the MOBOTIX MxManagementCenter software to find the current address.

Define specifically which areas in the image should trigger a recording. D. Recording & Storage

To access the open menu and internal configuration of a Mobotix M10 mobotix m10 open menu

If the previous owner changed the default password, you cannot open the menu. Power off the camera. Hold down the R button on the back using a paperclip, turn the power back on, and keep holding the button until the LEDs flash in a sequential pattern. This restores the admin / meinsm credentials.

Flash older M10 firmware to the last stable release provided by MOBOTIX to patch security vulnerabilities. Troubleshooting: What to Do If the Menu Won't Open : The factory default IP address for most

: Enter the default credentials if they haven't been changed: Username : admin Password : meinsm

Ensure the Ethernet cable is securely connected to the camera and your network switch or router. Hold down the R button on the back

If admin and meinsm do not work, the password was changed by a previous administrator. You must perform a hardware factory reset. For the M10, this requires opening the outer housing and bridging the specific reset contact pads or buttons on the internal circuit board during a power cycle.

With the network aligned, you are ready to open the WebUI configuration menu. 1. Address the Browser Compatibility Issue

Open your chosen web browser, click into the address bar, and type the camera's IP address. Press .