The left display tracks real-time hot air temperature. The right display tracks soldering iron temperature.
Place the heavy-duty soldering iron stand on a stable, heat-resistant surface next to the station. Moisten the cleaning sponge with water until damp, or place brass wool in the tray. 3. Connect the Handpieces
Clean the tip on damp brass wool or a wet sponge, then immediately apply a fresh layer of solder to protect the iron plating from rapid oxidation. Maintenance and Calibration gordak 952 user manual updated
Sets target temperature for the soldering iron ( 200∘C200 raised to the composed with power C 480∘C480 raised to the composed with power C
Controls the temperature from 150°C to 500°C (302°F to 932°F). The left display tracks real-time hot air temperature
Flip the hot air power switch to the "ON" position. The pump will immediately engage, and the LED screen will begin climbing to the temperature set by the dial.
Use a small flathead screwdriver to slowly turn the internal trimmer: Turn to increase the temperature. Turn counter-clockwise to decrease the temperature. Adjust until the external thermometer reads exactly 300°C. Calibrating the Hot Air Gun Moisten the cleaning sponge with water until damp,
Connect the 5-pin soldering iron plug into the front panel receptacle and screw the locking ring tight. Turn on the .
Understanding the limitations and power ratings of your equipment ensures safe operation and prevents damage to sensitive components.
Slide the assembly back into the handle handle and tighten the outer hardware. Troubleshooting Guide Probable Cause Corrective Action
